Install

Air Suspension Lowering Link Installation

Preparation Set your vehicle to service or tire-change mode — your owner's manual will walk you through it. Safely lift hte car on jack stands or a lift, and pull the wheel off. It may not be completely necessary depending on your vehicle, but a little extra room goes a long way.

Removal Carefully pry the stock sensor link from its ball joints, generally starting from the non-sensor arm side and set it aside. Just be mindful of the height sensors and their wiring nearby.

Installation Carefully snap your new link onto the height sensor ball joints. You can use a small flat head screwdriver to spread the link end slightly if you desire, but it is generally not needed. That's really all there is to it!

Verification Lower the car back down and take it out for a short highway drive. If no warning lights or fault codes show up after a few minutes, you're good to go — enjoy your new low car!